Stainless Steel Welding Wire and 'Fume'Jacketing for pipeline insulation new productStainless Steel - Pushing the Boundaries of Power GenerationStainless Steel Welding Wire - The Foundation of SkillWeldCoolMet for Stainless Steel Jacketing - Superior ReflectanceRevolutionary Stainless Steel Jacketing - Introducing SoundMetStainless Steel Wire - Industry meets ArtStainless Steel Springs - The Mighty Mity!Stainless Steel Welding Wire - Pure Diversity , Perfect QualityStainless Steel Wire - The Necessity of Quality
Stainless Steel wing seals are produced to hold tightly the stainless steel banding in place after tensioning of the banding around the cladding or insulation materials.
Manufactured from stainless steel 304 or 316. The base material is produced to the following specifications:
For further data on the Mechanical and physical properties of the stainless used see Product Data Sheet for stainless steel Banding (available form www.bsthermal.com)
Standard wing seals are pressed from stainless steel coil in either 0.5mm or 0.8mm dependent on the customer’s requirements. Most common widths are ½” (13mm) and ¾” (19mm)
Other sizes available ⅝” (16mm), 1” (25mm), 1½” (40mm) and 2” (50mm)
Once the banding is thread through the seals and tightened with a tensioning tool, the wings are flattened either by hammer type tool or by hand (0.5mm).
Seals are packed in either boxes of 1000 or sacks of 5000 although these can be adapted for special requirements. Material will packed on wooden pallets approximately 1000mm x 1200mm and shrink wrapped. Heat treated pallets will be supplied where
BS Thermal™ is a brand of BS Stainless Ltd
Web Design Lancashire by Brickweb